harescrambled

harescrambled

Lives in: Warren, OH USA

Member since: 04/01/08

Recent Activity Filter:

Added reply in a thread FX350- no oil top-end torched! 6/4/2020 3:51 PM

Engine Dynamics can fix the Head and cam cover.

Added reply in a thread camp coker roll call 5/28/2020 6:09 PM

If they do that, they can kiss the turnout goodbye. I'm not sure Id be interested in another Georgia round, and I can't do another Florida round

Added reply in a thread camp coker roll call 5/25/2020 2:20 PM

I'll be there

Added reply in a thread Opinions on running VP T4 fuel on a bran new stock 450. Is it worth it or no? 5/22/2020 2:24 PM

It's worth it to me because I'm racing all over, and I don't want to have to deal with inconsistent fuel/contaminated fuel, etc. T4 also exceeds the manufacturers required octane ratings.

Added reply in a thread gncc this weekend in ga 5/19/2020 6:32 PM

What class you run? I run Senior B

Added reply in a thread CRF450rx Sag and suspension setting 5/19/2020 6:31 PM

No trouble at all. I raced the stock clutch for two seasons. I just installed a Rekluse Torquedrive Manual...I like it, but I haven't raced it yet. Also, I have an ASV clutch perch and lever on it. This lets me put the clutch lever right where I want ... more »

Added reply in a thread Reluctantly finishing the season 5/18/2020 11:32 AM

Don't be surprised to see some unfamiliar faces in both classes...and a reduced number on the line. A good number of the 250 East (and likely 450) riders aren't going to be able to make the races....just not financially feasible

Added reply in a thread CRF450rx Sag and suspension setting 5/18/2020 11:26 AM

You are right at the top of the weight range it's set up for stock. I was 228lbs when I got my '18 450RX, and I had to get it resprung and revalved. I was clank bottoming everywhere...both ends were too soft even with the compression damping all the ... more »

Added reply in a thread gncc this weekend in ga 5/18/2020 10:49 AM

turnout was good: 642 in AM bike, 311 in PM bike

Added reply in a thread What bolts is the manual talking about lol 5/9/2020 1:12 PM

The engine mounting lower nut is the under the engine in the middle...the bolt for it goes through tabs on the frame cradle.

Added reply in a thread What bolts is the manual talking about lol 5/9/2020 1:10 PM

... more »

Added reply in a thread Best Coolant? 5/3/2020 11:25 AM

Freeze protection to -26F is legit. However, 256F boilover is misleading adspeak. The boiling point is increased so much due to being in a pressurized system. Not bagging on Dave or his product, but at sea level in an open container, Engine Ice boils ... more »

Added reply in a thread What Really Grinds my Gears - Global RAGE Thread 5/3/2020 11:15 AM

Part of that is the way California operates. Darn near anything can be used as a disability there. Blame your legislators for that one. I'm pretty sensitive to abuse of disabled access even now, as my former wife was disabled. She was never able to walk, ... more »

Added reply in a thread What Really Grinds my Gears - Global RAGE Thread 5/3/2020 10:12 AM

This one gets me...people who make assumptions that just because someone can walk without apparent difficulty, they're not legitimately disabled. There are numerous conditions which are legitimate disabilities...but are not obvious to the casual observer ... more »

Added reply in a thread Uber Eats - anyone use them? 5/3/2020 10:05 AM

I don't use Uber anything.... I object to the "sharing economy"..

Added reply in a thread Best Coolant? 5/3/2020 9:54 AM

The sarcasm was obvious my man. It's a meme for chrissakes!

laughing
By the way...you're wrong about basic solutions. basic solutions are very bad for aluminum. Dissolve some baking soda in water, drop a piece of uncoated aluminum into it, and wait ... more »

Added reply in a thread Wife spoke with her..... arrrrrr f$&@ it’s my cash. 5/3/2020 9:48 AM

That look is on point

smile
. It doesn't look like anyone else's HQV... A win there mate!

Added reply in a thread Water leak crf 450 17 5/2/2020 12:28 PM

It's press fit. You'll have to replace it. Whomever did your cerakote must have gotten it too hot. I overheated my 2018 CRF450RX quite badly, and the steel tube partially backed out of the aluminum cover, and began weeping coolant. I had to replace it.

... more »

Added reply in a thread Parting out 92/93 Suzuki rm 250 5/2/2020 12:06 PM

Check out this group on FB: https://www.facebook.com/groups/231474913851717/ advertise it there and you'll probably get rid of it quickly

Added reply in a thread Who's the Best rider to never win Championship in 450 class (or 250 b4 4 porkers) 4/25/2020 10:54 AM

X infinity