mx317

mx317

Lives in: TN, USA

Member since: 04/01/08

Recent Activity Filter:

Added reply in a thread Hard to start Husqvarna FC450 12/18/2019 5:07 AM

I may have to go that route or spring for a Vortex or Get unit.

Added reply in a thread 2019.5 husky fc450 12/16/2019 11:24 AM

Same here on the same model bike (Rockstar 450 Husqvarna)..

Added reply in a thread Hard to start Husqvarna FC450 12/16/2019 6:08 AM

I am really interested in the Vortex ECU, but it is a bit pricey.

Added reply in a thread Hard to start Husqvarna FC450 12/16/2019 5:13 AM

It has an idle adjustment knob and a start button which I think just cracks the throttle open slightly.

Added reply in a thread Hard to start Husqvarna FC450 12/16/2019 5:08 AM

Hit the starter button to prime the fuel pump, push up on the start button, hit the starter button once again to warm the battery and it used to would start on the third time spinning it over. This is the same I used with my 2017 KTM 450 SXF and it always ... more »

Started new thread Hard to start Husqvarna FC450 12/15/2019 5:54 PM

What I have is a Husqvarna Fc450 Rockstar bike 2018 (or some say 2018.5) which is very close to the 2019 450SXF. It is a bear to start when cold. I ran the battery down today trying to get it started and had to put in my spare battery. When it starts ... more »

This forum thread has 21 replies

Added reply in a thread Championship window is closing. 12/9/2019 6:53 AM

I think the odds are getting a little long, but he could still pull it off.

Added reply in a thread Twisted Development, $7000-dollar question, can you afford it?? 12/3/2019 5:21 AM

Twisted and Enzo know more than you.

Added reply in a thread WP / Trax shock service question 12/2/2019 12:30 PM

Is it the shock or Cone Valves that have to be sent? I know they required me to sent my Cone Valves to either CA or RI. They should all have the vacuum bleed systems.

Started new thread Loretta Lynn's Schedule 11/22/2019 1:25 PM

This forum thread has 2 replies

Added reply in a thread Alabama Area SX Tracks 11/11/2019 12:00 PM

At one time Sand Mountain had a SX track where the Vonlingers trained.

Added reply in a thread Vet National results? 11/3/2019 6:52 AM

MXA's website

Added reply in a thread MXA 2020 450 Shootout 10/24/2019 12:05 PM

Then you are still buying it.

Added reply in a thread MXA 2020 450 Shootout 10/24/2019 12:04 PM

Moran

Added reply in a thread Best goggles that don’t squeeze your nose? 10/23/2019 5:03 AM

I have had good luck with EKS Brand goggles. I wore the regular Oakley O-frames before.

Added reply in a thread Crickets Re:MEC 10/22/2019 7:28 AM

I think it is Moran on here.

Added reply in a thread SSS AER swap questions 10/19/2019 7:13 AM

After having two other very good companys do my Cone Valves, I had Enzo use regular mid-valves and they are awesome!

Added reply in a thread Honda CR-E news? 10/18/2019 1:16 PM

You are not very good at being a smart ass. You have to be smart to be a smart ass and if you are not, you are just an ass.

Added reply in a thread Factory KTM Bike Weight 9/30/2019 11:38 AM

3 lbs 2 ozs more according to my trusty postal scales. That will vary some with different springs and oil levels.

Added reply in a thread 2018 KTM 450 shock spring questions 9/28/2019 7:23 AM

About 105mm rider sag and 30-40mm of bike sag with no rider aboard. You should be ok in the ballpark with these numbers. You might like 108mm sag or 103mm, it's rider preference. Some can feel the difference in a few mm difference in sag and some can't. ... more »