Posts
10
Joined
10/23/2017
Location
CA
Edited Date/Time
10/30/2017 6:40am
Any feedback , comments or suggestions would be great from anyone that's done something similar , my stadium plate doesn't quite fit right , about 3/8 " gap between that and the fender , still have a ways to go needing new rads desperately , new graphics , sprockets and chain etc .
Much needed case saver
Bike has a full fmf
Pro taper bars
Rims from a 2015 crf250
Forks are off a 2005 crf250
Vforce reeds
New crank
New cylinder/head
Piston etc
All new plastics
New Michelin star cross
P.s this is my first post haha , and yeah I know the seat cover needs to be finished stapled
So none of these Pictures are in order , had to buy those rough looking forks because I manage to bend one of the kybs , but picked them up cheap couldn't complain .
The cylinder was shot , the piston made a mess of the head , so I figured I'd change the crank and bearings while I was at it
, I put about 20ish hrs on the first rebuild everything worked great , minus the hole in the outer clutch case .
Now 4 hours into the Second rebuild with the plastics yet to have seen the daylight
The Shop
Cool project
Post a reply to: 02 cr125 , first build , slow build *pics*