Posts
171
Joined
4/1/2008
Location
ID
US
Edited Date/Time
2/18/2021 4:31am
Hi All, i'm currently in parts hunting mode to gather the stuff for my next build, a HM Italy CRE250! i'm putting the word out to see if anyone has anything for a CRE. these things were rare when they were current, so parts are very tough to come by. I've found a few rare bits, but there are a few things i'm still looking for.... Below are a few examples of the bike
Acerbis 035 Spark arrestor/silencer and upper fork guards for Marzocchi Magnum 45mm Conventional forks.
The Shop
i have a NOS CRE kit (not for sale)...consider some Paioli forks as those were used as well..
Yellow front fender, conventional forks ... man!
Just any 125 enduro 2t is cool enough without it being vintage.
Slowly but surely inching ever closer.... found this NOS Acerbis rally front fender. These are a bit wider than a stock Honda fender and deflect mud/water better
Nice! Did you get them from parts-traders on eBay? That guy has all sorts of good stuff, I just got another set of old Acerbis handguards from him... what are you using those purple fork guards on?
Greg
Pit Row
the '90 will be cool, it's not as expensive as you think to find the original parts. most people don't know what they have, so it just takes more patience than money. i've been hunting CRE parts for two years, and don't have as much into it as you'd expect. Hit me up when you get started, I have an HRC lighting coil & heavy flywheel that will probably work on that bike.
I’m looking to make one like this from an ‘87
Greg
it's also worth mentioning that I tried to order a UFO enduro fender from MDracingproducts in the UK, the ones in the picture are what I wanted, but what showed up was a moto style CR fender with the large black taillight bolted under the fender. I've got nothing bad to say about how they handled the situation, but I was bummed that the pic was not correct, and they still haven't updated the listing with the correct photo.
Well if you see anymore for sale or if you decide to part with one of yours please let me know.
Another lucky break! found a set of Applied clamps that are made for the Marzocchi Magnum 45mm conventional forks!
Also found an unused set of those forks! i'll still have to figure out a caliper carrier, axle and wheel spacers, but this part of the project just got a lot easier.
I like your approach better ?
Sending you a message about the frame piece
Post a reply to: Honda CRE250 Enduro-Let's call it 97% Finished