Posts
129
Joined
3/7/2016
Location
Toowoomba
AU
Just planning my new project, I've got a 2014 KTM250SX with no front end. I've found a set of 2016 4cs forks off a 300exc and some 2016 neken sfs triples off a 450sxf.
My question is, as I'm putting a complete 2016 front end on, the geometry should remain the same as a 2014 front end?
But if I was to combine say, 2016 forks with 2014 triples then my geometry would be different as the 2016 forks lugs have the axle centre closer to the fork centre?
My question is, as I'm putting a complete 2016 front end on, the geometry should remain the same as a 2014 front end?
But if I was to combine say, 2016 forks with 2014 triples then my geometry would be different as the 2016 forks lugs have the axle centre closer to the fork centre?
Post a reply to: 2016 front end on 2014 KTM250SX