Posts
13
Joined
9/13/2018
Location
CA
Hey guys just pulled my head and the piston looks good so just gonna replace the rings , I am gonna hone the cylinder as there is a little bit of scoring markes on the exhaust size not enough for a re bore I think, Can I just use any cylinder hone from amazon of the store or are they specific?
Is the cylinder plated?
2 stroke or 4 stroke?
Have you measured the cylinder?
Have you ever done a hone job before?
Paw Paw
May be a waste of time and money if the bore is toast. Try your luck.
I’m new to the whole bike Seen I have a lot to learn
Appreciate the help guys
Paw Paw
The Shop
Thanks.
Post a reply to: Cylinder honing