Create New Tag
the 72nd goon the 72nd goon
9/18/2017 1:32 PM

I have delt with a few bikes where somebody disconnected the brake line and drained all the fluid out. It's really hard to get fluid flowing through the line again. You can buy a syringe and force it through line that way, but I wanted to share something I tried last night that worked. Hook a 2 ft piece of clear tubing to the bleeder nipple and run the other end into the hose of a shop vac, cup your hand over the vaccume hose to seal off the connection. Fill the master cylinder and turn on the shop vac. It takes about 30 seconds to suck fluid through the line. Next just bleed them like you normally would.

| Quote
ktm-5 ktm-5
9/18/2017 2:01 PM

Good to know thanks for the tip

| Quote
F150Motocrosser F150Motocrosser
9/19/2017 7:08 AM

Sounds like a pretty slick trick - but I have to ask, is this after trying something like a Mitey-Vac but without success?


Positively, absolutely 110% obsessed with anything MOTO.

| Quote
Acidreamer Acidreamer
9/19/2017 8:06 AM

Harbor freight vacuum bleeder works pretty good for this too lol

2009 Kawasaki KX450F
2009 Kawasaki KX250F
2002 Suzuki GSXR 600

| Quote
boston_jorj boston_jorj
9/19/2017 3:36 PM

Solid pro tip. I have Used the shop vac many times on different occasions. Has always worked in a pinch! But it's a bitch to clean brake fluid from the shop vac hose.

| Quote

Post a Reply

Cool Wink Smile Tongue Laughing Shocked Sick Angry Blink Sad Unsure Kissing Woohoo Grinning Silly Pinch Sideways Whistling Evil Dizzy Blush Cheerful Huh Dry